top of page
New holding tank
Removing the old steel holding tank
Very dirty job. The tank was full of sh.., since the pump was broke. So we had to empty it, before removing it. 80 liters is a lot of sh..!
If someone asks you to help remove something like this, just tell them, you are not available that date - even though you don´t know it!!!
A lot of cleaning in the bilge was needed
That´s better...
You can see the bow thruster in the picture...
I needed to remove some of the floor planking to get access to the old tank. Here you can see, that I installed new planks again, before putting the floor panels back on.
Done cleaning
New waste deckplate/cap for emptying the holding tank at a waste pump station in a marina
The new holding tank goes under the couch in the saloon
Cut a hole here...
Yes - that´s the way...
Ready for the holding tank to go in...
Macerator pump to cut the waste from the toilet into small particles
A little work is needed on the holding tank...
Type-plate
More holes drilled...
Hoses connected...
Test fitting the tank
A little more holes drilled...
In place
Almost done...
bottom of page